Car front bumper installation method?
The first is to install the side pedal. Prepare tools - socket (16, 14, 13, 12, 10, 8), adjustable wrench, flat wrench, ratchet, Phillips screwdriver, and flashlight
Lay down on the car and look for the bracket mounting holes Two holes in the original car were blocked by two rubber things
Put in the T-bolt because the side against the inside is a little lower so you need a pad
Install the rear bracket. When installing the rear bracket, it is necessary to remove the bolts of the original car. Here, a wrench of 13 is used, and then install a longer bolt card main bracket
Finally install the pedals to install the front bumper, you need to prepare the tools mentioned before plus an electric drill (7 bits) behind the hand of the front bumper
Remove the license plate and install the license plate of the plastic bracket Remove the buckle Remove the two buckle of the original car, lie down the car, you can see a row of buckle by the front, remove the most left and right
Screw on the support nut, it is recommended to use the self-locking nut to screw off the gap and plate after the support bolt is installed, install the rear bar, first install the stud on the rear bar, than on the original car, make a mark and drill holes
