2022 China New Design Mg 550 Spare Parts Factory - Original Vice Water Tank for SAIC MAXUS V80 C00002406 – Zhuomeng

Products Information

Product display

Product knowledge

Automobile water tank, also known as radiator, is the main part of automobile cooling system; Its function is to dissipate heat. The cooling water absorbs heat in the water jacket, dissipates the heat after flowing to the radiator, and then returns to the water jacket for continuous circulation. So as to achieve the effect of heat dissipation and temperature regulation. It is also an important part of automobile engine.

water tank

The water tank is an important component of the water-cooled engine. As an important component of the heat dissipation circuit of the water-cooled engine, it can absorb the heat of the cylinder block and prevent the engine from overheating. Due to the large specific heat capacity of water, the temperature rise after absorbing the heat of the cylinder block is not much, so the heat of the generator passes through the liquid circuit of cooling water and uses water as a heat carrier to conduct heat, Then heat is dissipated by convection through a large area of heat sink to maintain the appropriate working temperature of the engine.

When the water temperature of the engine is high, the water pump circulates repeatedly to reduce the temperature of the engine (the water tank is composed of hollow copper pipes. The high-temperature water enters the water tank and circulates to the engine cylinder wall after air cooling) to protect the engine. If the water temperature is too low in winter, the water circulation will be stopped to avoid too low engine temperature.

matters needing attention

1. The radiator shall not come into contact with any acid, alkali or other corrosive properties. 2. It is recommended to use soft water. Hard water should be used after softening treatment to avoid blockage and scale in the radiator.

3. When using antifreeze, in order to avoid the corrosion of radiator, please be sure to use the long-term anti rust antifreeze produced by regular manufacturers and in line with national standards.

4. During the installation of the radiator, please do not damage the radiator (sheet) and bruise the radiator to ensure the heat dissipation capacity and sealing.

5. When the radiator is completely drained and then filled with water, turn on the water drain switch of the engine block first, and then close it when water flows out, so as to avoid blisters.

6. Check the water level at any time during daily use, and add water after shutdown and cooling. When adding water, slowly open the water tank cover, and the operator’s body should be as far away from the water inlet as possible to prevent scald caused by high-pressure steam ejected from the water inlet.

7. In winter, in order to prevent the core from cracking due to icing, such as long-term shutdown or indirect shutdown, the water tank cover and drain switch shall be closed to drain all the water.

8. The effective environment of the standby radiator shall be ventilated and dry.

9. Depending on the actual situation, the user shall completely clean the core of the radiator once in 1 ~ 3 months. When cleaning, wash with clean water along the side of the reverse inlet wind direction. Regular and complete cleaning can prevent the radiator core from being blocked by dirt, which will affect the heat dissipation performance and the service life of the radiator.

10. The water level gauge shall be cleaned every 3 months or as the case may be; Remove all parts and clean them with warm water and non corrosive detergent.

Customer evaluation